Installation Instructions Section 2
2-8
Part Number 000001590
Drain Pump Option
1. Remove top cover screws and slide cover off.
Remove back panel screws and lift panel off.
2. Assemble the outlet tube and vent tube to the drain
pump.
3. Plug the drain pump’s wire assembly into the ice
machine’s wire assembly. Slide drain pump into
cavity.
4. Swap out existing Bin Drain Tube for Bin Drain Tube
packaged with drain pump.
5. Route the vent tube and outlet tube.
6. Reassemble ice machine.
NOTE: See instructions packaged with drain pump for
details. Drain pump available for purchase at
www.compact-ice.com.
Leg Option
1. Remove the leg levelers from the bottom of the ice
machine.
2. Screw the legs into the bottom of the ice machine.
3. Screw the foot of each leg in as far as possible.
4. Move the ice machine to its final position.
5. Level the ice machine to assure that the bin door
closes and seals properly. Use a level on top of the
bin. Turn the base of each foot as necessary to level
the bin.
Adjusting Leg
Disconnect power to ice machine before proceeding.
Upon activation, be sure to check all connections for
water leakage.
To Next Page
Loading...
Need help?
General
