Section 4 Maintenance
Part Number 000001590 4-5
REMOVAL OF PARTS FOR CLEANING/SANITIZING
1. Turn off the electrical and water supply to the ice
machine.
2. Remove all ice from the bin.
3. Remove the components that must be cleaned and
sanitized. See the following pages for removal
procedures for these parts.
4. Soak the removed part(s) in a properly mixed
solution of cleaner.
5. The cleaner will foam; once the foaming stops use a
soft-bristle nylon brush, sponge or cloth (NOT a wire
brush) to carefully clean the parts.
6. Thoroughly rinse all the parts with clear water.
7. Soak the removed parts in a properly mixed solution
of sanitizer for 5 minutes.
8. Use a soft-bristle nylon brush, sponge or cloth (NOT
a wire brush) to carefully sanitize the parts.
9. Use the sanitizing solution and a sponge or cloth to
sanitize (wipe) the interior of the ice machine and
bin.
10. Rinsing is not required when using Manitowoc
Sanitizer.
11. Install the removed parts.
12. Turn on the water and electrical supply.
Disconnect electric power to the ice machine before
proceeding.
Wear rubber gloves and safety goggles (and/or face
shield) when handling Ice Machine Cleaner or
Sanitizer.
Solution Type Water Mixed With
Cleaner 1 gal. (4 l) 8 oz (240 ml) cleaner
Sanitizer 2 gal. (8 l) 1 oz (30 ml) sanitizer
Do not mix Cleaner and Sanitizer solutions together.
It is a violation of Federal law to use these solutions
in a manner inconsistent with their labeling.
Do not immerse the water pump motor in the
cleaning or sanitizing solution.
To Next Page
Loading...
Need help?
General
