Maintenance Section 4
4-6
Part Number 000001590
Top Cover
1. Remove two back screws.
2. Slide back and lift cover off.
Water Shutters
The water shutter is designed to keep the spraying water
from escaping the evaporator compartment.
To remove just the water shutters:
1. Grasp one end of the water shutter and lift up.
2. Pivot water shutter and disengage remaining end.
3. To re-install into ice machine, grasp one end of the
water shutters, install one end, pivot the opposite
end and pull down into position. Make sure tabs are
secure in grooves.
To remove water shutter assembly:
1. Slide evaporator bucket forward 1/2” (13 mm).
2. Lift shutter assembly straight up.
Disconnect the electrical power to the ice machine
at the electrical disconnect before proceeding.
Removing the water shutters while the water pump
is running will allow water to spray from ice
machine. Disconnect the electrical power to the ice
machine at the electric service switch box and turn
off the water supply.
Shutter
Assembly
Water
Shutters
Grasp
Water
Shutters
Here
To Next Page
Loading...
Need help?
General
