Section 3 Ice Machine Operation
Part Number 000001590 3-5
CUBE WEIGHT ADJUSTMENT
The cube weight can be increased from the factory
setting by adjusting the finish time.
Additional finishing time check:
1. Press and hold the power button for 5 seconds.
2. Count the flashes on the Automatic Ice Making light.
The light will flash once for each additional minute of
freeze cycle time.
Adjusting Finishing Time
Adjust in 1 minute increments and allow the ice machine
to run several freeze/harvest cycles, then inspect the ice
cubes. If a heavier cube weight is desired add another
minute of freeze time and repeat the process.
1. Press and hold the power button.
2. Press and release the clean button once for each
additional minute of freeze cycle time desired.
3. Five minutes is the maximum additional freeze time
that can be added. Pressing the clean button 6 times
will reset the finishing time to zero additional
minutes.
Cube weight increases or decreases depending on
the amount of dimple in the cube
To Next Page
Loading...
Need help?
General
