To Next Page

To Previous Page

34 Part Number 000014797 Rev02 05/18

Remove Parts for Cleaning

Warning

Disconnect electric power to the ice machine at the

electric switch box before proceeding.

1. Remove the Harvest Float Switch and Ice Thickness

Float Switch

• Pull forward on the bottom of the bracket until

clear of the tab, then slide bracket upward to

remove the bracket and float as an assembly. At

this point, the float switches can easily be cleaned.

If complete removal is desired, follow the wires

to the bulkhead grommet (exit point) in the back

wall. Pull the wire connector through the bulkhead

grommet, then disconnect the wire leads from the

connector.

NOTE: The wire from the top grommet goes to the ice

thickness float switch (front switch). The wire from the

bottom grommet goes to the Harvest float switch (side

switch).

Important

Reversing the mounting location of the ice thickness and

the harvest floats will result in a safety limit 2 failure.

• The ice thickness float must be mounted to the front

of the water trough and the electrical connection must

be in the top bulkhead grommet.

• The harvest float must be mounted to the side of the

water trough and the electrical connection must be in

the bottom bulkhead grommet.

• The wire connectors for each float are different and

will not allow incorrect electrical bulkhead connection.

Manitowoc URF0140A Technician's Handbook

Other manuals for Manitowoc URF0140A