Marshall Amplification CV630-IP User Manual

English - 19
■ RS-422 connection instructions
1. Hold the two sides of RS-422 connector and pull out in the direction shown by the
arrow in the figure below
2. Peel off a section of copper wire (AWG Nos. 28 to 18) and insert it into the connector
hole; then use flat screwdriver to tighten it into place.
3. Insert the wired RS-422 connector back to the Camera. Now the connection is
completed
English - 20
Chapter 5 Remote Control and Setting Menu
5.1 Functions of remote control
<Remark> The below functions are listed alphabetically.
Item
Description

,

,

,


Move the lens
Back Light
Turn on/off back light compensation
Camera select
Choose Camera ID 1 ~ 3
Focus-
Manual /
Far/Near
Turn on manual focus to adjust the focal
length
Focus-Auto
Auto Focus
Freeze
Freeze the image on screen
Home-Enter
Go back to the main page / Execute
Info
Status information
L/R
Direction Set
L/R Direction / Normal
Menu
Display OSD menu
Mirror
Rotate the image (OFF / Mirror / Flip /
Rotate)
Pan/Tilt
Reset
Clear the Pan / Tilt setting
Picture
Switch image effect (OFF / Neg / B&W)
Power
Power Switch
Preset
Appoint an ID (0 ~ 9) to save the current
position data
Reset
Appoint an ID (0 ~ 9) to delete the
current position data
Zoom-Fast
Adjust image size
Zoom-Slow Fine-tune image size
CV630-IP Manual
www.marshall-usa.com19 20

Marshall Amplification CV630-IP Specifications

General

Brand	Marshall Amplification
Model	CV630-IP
Category	Security Camera
Language	English