TWO-SPEED GEAR BOX SWITCH – cont’d
NOTES:
a) Use low-speed setting for drilling large
holes and for driving screws.
b) Use high-speed setting for drilling
smaller holes.
c) Do NOT change the speed-control
switch position while drill is turned ON.
Damage to the gears may result.
FORWARD/REVERSE SWITCH
The forward/reverse switch (1) is
conveniently mounted above the trigger
switch (2) (Fig. 8). To make the drill rotate
clockwise for drilling or driving screws,
push the forward/reverse switch to the left.
To make the drill rotate counter-clockwise
for removing screws, push the
forward/reverse switch to the right.
NOTES:
a) Never change the position of the
forward/reverse switch while the hex drive
is turning.
b) The trigger switch will NOT function with
the forward/reverse switch in the middle
position.
VARIABLE-SPEED TRIGGER SWITCH
This drill is equipped with a variable-speed
ON/OFF trigger switch.
To start the drill, gently squeeze the trigger
switch (2) (Fig. 9). The harder you
squeeze the trigger, the faster the drill will
rotate.
To Next Page
Loading...
Need help?
General
