DRIVING SCREWS – cont’d
3. Set the two speed gear box to the low
speed setting (Fig. 7).
NOTES:
a. If material is particularly soft or
porous, use slower motor speeds.
Only slightly squeeze the trigger
switch to avoid overdriving the screw.
b. Avoid prolonged driving of screws
using lower motor speeds. Prolonged
lower motor speeds will produce
excessive current draw by the motor
and reduced cooling by the cooling
fan. If the tool gets hot, stop driving
screws for at least 15 minutes to allow
the motor to cool.
To Next Page
Loading...
Need help?
General
