Matrix ClimbMill C50-F User Manual

6
CHAPTER 2: IMPORTANT SAFETY INSTRUCTIONS
2.4 STABILIZING THE CLIMB MILL
LEVELING THE EQUIPMENT
Locate a level, stable surface to position the equipment. The equipment has levelers located below the Control Zone
step. Raise or lower one or both of the adjustable levelers using a 6mm allen wrench through the access hole.
A carpenter’s level is recommended.
NOTE: There are only two levelers on the equipment.
LEVELER

Matrix ClimbMill C50-F Specifications

General

Brand	Matrix
Model	ClimbMill C50-F
Category	Fitness Equipment
Language	English