34
NO RECEPTION ON THE TV OR IT IS BLURRY
POSSIBLE CAUSES:
1) The coax signal is not being sent strongly enough for good TV reception.
2) The coax cable is pinched or installed incorrectly.
3) The TV is defective.
SOLUTION:
1) Check that the TV is programed correctly by following the instructions in Section 10.4.
2) Test the coax signal from the wall by plugging it into a known working TV.
3) Remove any coax cable splitters and reattach the cable to the treadmill. If this resolves the issue, an amplifier may be needed on for the
coax signal.
4) Check the coax cable connections at the treadmill (3 locations, Figures A-C).
5) Attach the coax cable from the wall directly into the coax connector in the console shown in Figure C. If this resolves the issue, replace the
internal coax cable in the treadmill.
6) If all other issues have been eliminated, replace the console.
FIGURE A FIGURE B
FIGURE B
8.4 TROUBLESHOOTING - TV RECEPTION ISSUES
CHAPTER 8: TROUBLESHOOTING
To Next Page
Loading...
Need help?
General
