Matrix T1XE-01 User Manual

37
9.3 DECK REMOVAL
1) Remove the front shroud as outlined in Section 9.1.
2) Remove the four deck screws using a 5 mm Allen wrench (Figure A).
3) Remove the deck from the running belt (Figures B & C).
4) Be careful not to pinch fingers during removal / installation of deck board.
5) Deck is waxed on both sides so the opposite side surface may be usable.
6) New deck surfaces must ALWAYS be matched to a new running belt.
7) Test the treadmill for function as outlined in Section 9.22.
FIGURE A FIGURE B
FIGURE C
CHAPTER 9: PART REPLACEMENT GUIDE

Matrix T1XE-01 Specifications

General

Brand	Matrix
Model	T1XE-01
Category	Treadmill
Language	English