McQuay MCK 020A User Manual

Remote Control Operation Guide
G6 Remote Controller
AUTOMATIC AIR SWING
• Press the button to
activate the automatic air
swing function. The
swing angle ranging from
horizontal to 25° to
bottom.
FAN SPEED AND
VENTILATION MODE
SELECTION
Press the button until
the desired fan speed is
achieved.
7
OPERATION MODES
• Press the “mode” button
for select the type of
operating mode.
• Cooling only unit:
Cool →Dry →Fan.
eatpump unit :
Auto →Cool →Dry
• H
6
8
SIGNAL TRANSMISSION
INDICATION
• Blink to confirm the
last setting has been
send to the unit.
TEMPERATURE SETTING
• Set the desire room
temperature.
• Press button to increase
or decrease the set
temperature. Setting
range are between 16°C
to 30°C setting (60°F to
80°F)(Optional setting
from 20°C to 30°C).
• Press  or  button
simultaneously will
toggle the temperature
setting between °C and
°F.
2
TIMER SETTING
• Press set button to
activate the timer setting
(from 1 hour to 15 hour)
of the air conditioning
unit. It will be in "On" or
"Off" condition after the
set time depending to the
current condition (either
from "On" to Off" or vise
versa)
• To cancel the timer
setting, press the button
continuously until the
timer display goes off.
5
SLEEP MODE
• Press the button to activate sleep
mode. This mode can only be
activated while in cooling or
heating mode operation. If it is
activated in “COOL” mode, the
set temperature will be increase
0.5°C after 30 minutes, 1°C after
1 hour and 2°C after 2 hours.
Whereas in “HEAT” mode, the
set temperature will decrease by
1°C after 30mins, 2°C after 1
hour and 3°C after 2 hours.
• This function is available under
COOL, HEAT & AUTO mode.
4
1
ON / OFF switch
• Press to start the air
conditioner unit.
• Press again to stop the
unit.
3
85

McQuay MCK 020A Specifications

General

Brand	McQuay
Model	MCK 020A
Category	Air Conditioner
Language	English