IOMM Starter 15
Figure 4, Field Wiring for Optional D3 Communication
NOTES.
1. See Figure 3 for Starter connection location.
2. The compressor controller serial card location is in the lower-center of the compressor
controller, under the operating buttons.
3. The bias block is located on the rail, just to the left of the compressor controller.
4. Note that the connections are (-) to (-), (+) to (+), and SCOM to GND, with a shield
connection on the starter terminal board.
Medium/high Voltage Starters
Control wiring for medium and high voltage solid state and across-the-line starters is per the
wiring diagram on page 16.
To Next Page
Loading...
Need help?
General
