266
Operation
Maintenance
The Mercedes-Benz Center will reset the
service indicator following a completed
service.
Calling up the service indicator
왘 Switch on ignition.
The standard display of the control
system appears (
컄 page 113).
왘 Press button k or j on the mul-
tifunction steering wheel until the FSS
indicator appears in the multifunction
display.
Resetting the service indicator
In the event that the service on your
vehicle is not carried out by an authorized
Mercedes-Benz Center, you can reset the
service indicator yourself.
왘 Switch on ignition.
The standard display of the control
system appears (
컄 page 113).
왘 Press button k or j on the mul-
tifunction steering wheel until the FSS
indicator appears in the multifunction
display.
왘 Press reset button for about three
seconds.
This message appears in the multifunc-
tion display:
SERVICE INTERVAL?
RESET WITH R BUTTON FOR 3 SEC.
왘 To confirm, press reset button until you
hear a signal.
The service indicator now displays the
reset interval.
i
If the battery is disconnected, the days
of disconnection will not be included in
the count shown by the service indica-
tor. To arrive at the true service
deadline, you will need to subtract
these days from the days shown in the
service indicator.
Do not confuse the service indicator
with the engine oil level indicator :.
i
If the service indicator was
inadvertently reset, have a
Mercedes-Benz Center correct it.
Only reset if the proper service has
been performed. Resetting the system
without performing proper service as
called for by the FSS will cause the FSS
to incorrectly determine the next
service interval which will result in
engine damage not covered by the
Mercedes-Benz Limited Warranty.
To Next Page
Need help?
General
