302
Controls in detail
Useful features
Interior rear view mirror with integrated re-
mote control
1 Indicator lamp
2 3 4 Signal transmitter button
Needed for programming (not part of
vehicle equipment):
5 Hand-held remote control of ga-
rage door opener, gate operator
or other device
6 Hand-held remote control
button
Programming the integrated remote
control
Step 1:
왘 Switch on the ignition (컄 page 40).
Step 2:
왘 If you have previously programmed a
signal transmitter button and wish to
retain its programming, proceed to
step 3.
If you are programming the integrated
remote control for the first time, press
and hold the two outer signal transmit-
ter buttons 2 and 4 and release
them only when indicator lamp 1
Warning! G
Before programming the integrated remote
control to a garage door opener or gate
operator, make sure people and objects are
out of the way of the device to prevent po-
tential harm or damage. When programming
a garage door opener, the door moves up or
down. When programming a gate operator,
the gate opens or closes.
Do not use the integrated remote control
with any garage door opener that lacks
safety stop and reverse features as required
by U.S. federal safety standards (this
includes any garage door opener model
manufactured before April 1, 1982).
A garage door that cannot detect an object
– signaling the door to stop and reverse –
does not meet current U.S. federal safety
standards.
When programming a garage door opener,
park outside the garage.
Do not run the engine while programming
the integrated remote control. Inhalation of
exhaust gas is hazardous to your health. All
exhaust gas contains carbon monoxide
(CO), and inhaling it can cause unconscious-
ness and possible death.
To Next Page
Loading...
Need help?
General
