378
Practical hints
What to do if …?
Lamps in instrument cluster General information:
If any of the following lamps in the instru-
ment cluster fails to come on during the
bulb self-check when switching on the igni-
tion, have the respective bulb checked and
replaced if necessary.
Problem Possible cause/consequence Suggested solution
- The yellow ABS indicator lamp
comes on while the engine is
running.
The ABS has detected a malfunction and has
switched off. The BAS and the ESP
®
are also
switched off (see messages in the multifunc-
tion display).
The brake system is still functioning normally
but without the systems specified above.
If the ABS control unit is malfunctioning,
other systems such as the navigation
system* or the automatic transmission may
also be malfunctioning.
왘 Continue driving with added caution.
Wheels will lock during hard braking,
reducing steering capability.
왘 Read and observe messages in the
multifunction display (
컄 page 394).
왘 Have the system checked at an autho-
rized Mercedes-Benz Center as soon
as possible.
Failure to follow these instructions in-
creases the risk of an accident.
The charging voltage has fallen below
10 volts. The ABS has switched off. The BAS
and the ESP
®
are also switched off (see mes-
sages in the multifunction display)
The battery might not be charged sufficiently.
왘 Switch off electrical consumers that
are currently not needed, e.g. seat
heating*.
왘 If necessary, have the generator and
battery checked.
When the voltage is above this value
again, the ABS is operational again.
To Next Page
Loading...
Need help?
General
