Mercedes-Benz 2008 CLK-Class User Manual

448
Practical hints
Replacing bulbs
왘 Reinsert bulb holder 4 with the bulb in
the lamp and turn clockwise.
왘 Align housing cover 2 and turn it
clockwise.
Front turn signal lamp bulb
왘 Turn bulb socket 1 counterclockwise
and remove it.
왘 Press gently onto the bulb and turn
counterclockwise out of bulb
socket 1.
왘 Press the new bulb gently into bulb
socket 1 and turn clockwise until it
engages.
왘 Place bulb socket 1 back into the
lamp and turn it clockwise.
Parking and standing lamp bulb
왘 Turn housing cover 2 counterclock-
wise and remove it.
왘 Pull out bulb socket 5 with the bulb.
왘 Pull the bulb out of the bulb socket 5.
왘 Press the new bulb into bulb socket 5.
왘 Press bulb socket 5 back into the
lamp.
왘 Align housing cover 2 and turn it
clockwise.
Additional turn signal lamps
The additional turn signal lamps in the ex-
terior rear view mirrors have LEDs.
If a malfunction occurs or LEDs fail to func-
tion, the entire turn signal unit must be re-
placed. Have the additional turn signal unit
replaced at an authorized Mercedes-Benz
Center.
Front side marker lamp
Since replacing the side marker lamp bulbs
is a technically highly demanding process,
we recommend you have the side marker
lamp bulbs replaced at an authorized
Mercedes-Benz Center.
Replacing bulbs for rear lamps
Before you start to replace a bulb for a rear
lamp, do the following first:
왘 Turn the exterior lamp switch to
position M (
컄 page 129).
Tail lamp unit
왘 Open trunk lid.
왘 Swing the trim panel covering the
corresponding rear lights to the side.
1 Connector
2 Tab
왘 Disconnect electrical connector 1.
컄컄

Mercedes-Benz 2008 CLK-Class Specifications

General

Brand	Mercedes-Benz
Model	2008 CLK-Class
Category	Automobile
Language	English