Lighting
98
1
Memory position button
2
Memory button M
Storing positions into memory
X
Adjust the seats, on the driver’s side also
the steering wheel and exterior rear view
mirrors, to the desired positions.
X
Press memory button M.
X
Release memory button M and press mem-
ory position button 1, 2 or 3 within 3 sec-
onds.
When the settings are stored to the
selected position, an acknowledgement
signal sounds.
Recalling positions from memory
X
Press and hold desired memory position
button 1, 2 or 3 until the seat, on the
driver’s side also the steering wheel and
exterior rear view mirrors, have completely
moved to the stored positions.
i
Releasing the memory position button
stops movement to the stored positions
immediately.
Lighting
Notes
i
If you drive in countries where vehicles
drive on the other side of the road than the
country where the vehicle is registered, you
must have the headlamps modified for
symmetrical low beams. Relevant informa-
tion can be obtained at any authorized Mer-
cedes-Benz Center.
i
The active Bi-Xenon headlamps monitor
the vehicle’s steering angle and speed,
then automatically shift their beams to
either side to better follow the curvature of
the road ahead, increasing usable illumina-
tion over conventional headlamps.
Controls in detail
To Next Page
Loading...
Need help?
General
