Mounting a new wheel
G
WARNING
Oiled or greased wheel bolts or damaged
wheel bolts/hub threads can cause the wheel
bolts to come loose. As a result, you could
lose a wheel while driving. There is a risk of
accident.
Never oil or grease wheel bolts. In the event of
damage to the threads, contact a qualified
specialist workshop immediately. Have the
damaged wheel bolts or hub threads
replaced/renewed. Do not continue driving.
G
WARNING
If you tighten the wheel bolts or wheel nuts
when the vehicle is raised, the jack could tip
over. There is a risk of injury.
Only tighten the wheel bolts or wheel nuts
when the vehicle is on the ground.
Always pay attention to the instructions and
safety notes in the "Changing a wheel" sec-
tion (
Y page 330).
Only use wheel bolts that have been designed
for the wheel and the vehicle. For safety rea-
sons, Mercedes-Benz recommends that you
only use wheel bolts which have been
approved for Mercedes-Benz vehicles and the
respective wheel.
!
To prevent damage to the paintwork, hold
the wheel securely against the wheel hub
while screwing in the first wheel bolt.
X
Clean the wheel and wheel hub contact
surfaces.
X
Slide the wheel to be mounted onto the
alignment bolt and push it on.
X
Tighten the wheel bolts until they are fin-
ger-tight.
X
Unscrew the alignment bolt.
X
Tighten the last wheel bolt until it is finger-
tight.
X
Vehicles with a collapsible spare wheel:
inflate the collapsible spare wheel
(
Y page 340). Only then lower the vehicle.
Lowering the vehicle
G
WARNING
The wheels could work loose if the wheel nuts
and bolts are not tightened to the specified
tightening torque. There is a risk of accident.
Have the tightening torque immediately
checked at a qualified specialist workshop
after a wheel is changed.
X
Turn the crank of the jack counter-clock-
wise until the vehicle is once again standing
firmly on the ground.
X
Place the jack to one side.
X
Tighten the wheel bolts evenly in a cross-
wise pattern in the sequence indicated (:
to A). The specified tightening torque is
96 lb-ft (130 Nm).
X
Turn the jack back to its initial position.
X
Stow the jack and the rest of the vehicle
tools in the trunk again.
334
Changing a wheel
Wheels and tires
To Next Page
Loading...
Need help?
General
