141
Controls in detail
Memory function*
ì™” Memory function*
Prior to operating the vehicle, the driver
should check and adjust the seat height,
seat position fore and aft, and seat back-
rest angle if necessary, to ensure adequate
control, reach and comfort. The head
restraint should also be adjusted for
proper height. See also the section on
air bags (
컄 page 76) for proper seat posi-
tioning.
In addition, adjust the steering wheel to
ensure adequate control, reach, operation
and comfort. Both the interior and exterior
rear view mirrors should be adjusted for
adequate rear vision.
Fasten seat belts. Infants and small chil-
dren should be seated in a properly se-
cured restraint system that complies with
U.S. Federal Motor Vehicle Safety Stan-
dards 213 and 225 and Canadian Motor
Vehicle Safety Standards 213 and 210.2.
With the memory function you can store up
to three different configurations.
Each stored position on the driver’s side
includes the following settings:
ì•« Seat position
ì•« Multicontour seat*: previously saved
setting
ì•« Steering wheel position
앫 Exterior rear view mirrors’ position
Each stored position on the passenger side
includes the following settings:
ì•« Seat position
ì•« Multicontour seat*: previously saved
setting
The memory button and stored position
buttons are located on the entry side of
each front seat base.
M Memory button
1, 2, 3 Stored position buttons
Warning! G
Do not activate the memory function while
driving. Activating the memory function
while driving could cause the driver to lose
control of the vehicle.
164.boo Seite 141 Freitag, 30. März 2007 12:54 12
To Next Page
Loading...
Need help?
General
