184
Controls in detail
Control system
왘 Press button æ or ç repeatedly
until the desired speed is shown in the
multifunction display.
When DSR is switched on, DSR will use
the programmed default speed to regu-
late the vehicle’s speed.
Trip computer menu
Use the trip computer menu to call up
statistical data on your vehicle.
The following information is available:
Fuel consumption statistics since start
왘 Press button ÿ or è repeatedly
until the message
From Start
appears
in the multifunction display.
1 Distance driven since start
2 Time elapsed since start
3 Average speed since start
4 Average fuel consumption since start
i
Once DSR is switched on, you can adjust the
set speed using the cruise control lever
(
컄 page 276).
Function Page
Fuel consumption statistics
since start
184
Fuel consumption statistics
since last reset
185
Resetting fuel consumption
statistics
185
Distance to empty 185
i
When you enter the trip computer menu, you
will always see the fuel consumption statistics
since start first.
i
All statistics stored since the last engine
start will be reset approximately 4 hours after
the SmartKey in the starter switch is turned to
position 0 or removed from the starter switch.
Resetting will not occur if you turn the SmartKey
back to position 1 or 2 within this time period.
컄컄
164.boo Seite 184 Freitag, 30. März 2007 12:54 12
To Next Page
Loading...
Need help?
General
