511
Practical hints
Replacing bulbs
4 Bulb socket of front fog lamp bulb
왘 Turn bulb socket 4 counterclockwise.
왘 Pull bulb socket 4 out of the housing.
왘 Pull the front fog lamp bulb out of bulb
socket 4.
왘 Insert the new front fog lamp bulb into
bulb socket 4.
왘 Insert bulb socket 4 into the housing.
왘 Turn bulb socket 4 clockwise until it
engages.
왘 Plug in the electrical connector.
왘 Insert front fog lamp 2 back into
bumper.
왘 Fasten retaining screws 3.
왘 Reinsert cover 1 and press it in until it
engages.
Additional turn signal lamps bulbs
The additional turn signal lamps in the
exterior rear view mirrors have LEDs.
If a malfunction occurs or LEDs fail to func-
tion, the entire turn signal unit must be re-
placed. Have the turn signal unit replaced
by an authorized Mercedes-Benz Light
Truck Center.
Replacing bulbs for rear lamps
Before you start to replace a bulb for a rear
lamp, do the following first:
왘 Turn the exterior lamp switch to
position M (
컄 page 143).
Tail lamp unit
왘 Open the tailgate (컄 page 122).
i
To access the bulb socket, you have to
remove the cover in the corresponding side trim
panel of the cargo compartment.
164.boo Seite 511 Freitag, 30. März 2007 12:54 12
To Next Page
Loading...
Need help?
General
