268
Controls in detail
Useful features
Operation of integrated remote control
왘 Switch on the ignition (컄 page 34).
왘 Select and press the appropriate inte-
grated signal transmitter button (2,
3 or 4) to activate the remote con-
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
Erasing the integrated remote control
memory
왘 Switch on the ignition (컄 page 34).
왘 Simultaneously hold down the signal
transmitter buttons 2 and 4, for ap-
proximately 20 seconds, until the indi-
cator lamp 1 flashes rapidly. Do not
hold for longer than 30 seconds.
The codes of all three channels are
erased.
Reprogramming a single integrated sig-
nal transmitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
왘 Press and hold the desired signal trans-
mitter button (2, 3 or 4). Do not re-
lease the button.
왘 The indicator lamp 1 will begin to
flash after 20 seconds. Without releas-
ing the integrated signal transmitter
button, proceed with programming
starting with step 3.
i
If you sell your vehicle, erase the codes
of all three channels.
To Next Page
Loading...
Need help?
General
