36
Getting started
Unlocking
Position 0
Before you press the KEYLESS-GO
start/stop button 1, the vehicle’s
on-board electronics have status 0 (as with
SmartKey removed).
Position 1
왘 Press KEYLESS-GO start/stop
button 1 once.
This supplies power for some electrical
consumers, such as seat adjustment.
Ignition (or position 2)
왘 Press KEYLESS-GO start/stop
button 1 twice.
This supplies power for all electrical
consumers.
All lamps (except high beam headlamp
indicator lamp and turn signal indicator
lamps unless activated) in the instru-
ment cluster come on. If a lamp in the
instrument cluster fails to come on
when the ignition is switched on, have
it checked and replaced if necessary.
If a lamp in the instrument cluster re-
mains on after starting the engine or
comes on while driving, refer to “Lamps
in instrument cluster” (
컄 page 340).
For information on starting the engine us-
ing the KEYLESS-GO start/stop button,
see “Starting with KEYLESS-GO*”
(컄 page 47).
i
If you now press the KEYLESS-GO
start/stop button
앫 once again, the ignition (position 2)
is switched on
앫 twice, the power supply is again
switched off
i
If you now press the KEYLESS-GO
start/stop button once, the power sup-
ply is again switched off.
i
When you switch on the ignition, the in-
dicator and warning lamps (except high
beam headlamp indicator lamp and
turn signal indicator lamps unless acti-
vated) in the instrument cluster come
on. The indicator and warning lamps
(except high beam headlamp indicator
lamp and turn signal indicator lamps if
activated) should go out when the en-
gine is running. This indicates that the
respective systems are operational.
To Next Page
Loading...
Need help?
General
