MAINTENANCE
56
CLEANING AND WAXING PROCEDURE
1. Before washing, rinse the top cowl with clean water to remove
dirt and dust that may scratch the surface.
2. Wash the top cowl with clean water and a mild non‑abrasive
soap. Use a soft clean cloth when washing.
3. Dry thoroughly with a soft clean cloth.
4. Wax the surface using a non‑abrasive automotive polish
(polish designed for clear coat finishes). Remove the applied
wax by hand using a clean soft cloth.
Alternator Belt Inspection
1. Inspect the alternator belt and have it replaced by an
authorized dealer if any of the following conditions are found.
a. Cracks or deterioration in the rubber portion of the belt.
b. Belt surfaces rough or uneven.
c. Signs of wear on edges or outer surfaces of belt.
Fuel System
!
WARNING
Fuel is flammable and explosive. Ensure the key switch is off and
the lanyard is positioned so that the engine cannot start. Do not
smoke or allow sources of spark or open flame in the area while
servicing. Keep the work area well ventilated and avoid
prolonged exposure to vapors. Always check for leaks before
attempting to start the engine and wipe up any spilled fuel
immediately.
To Next Page
Loading...
Need help?
General
