MAINTENANCE
60
!
WARNING
Improper fasteners or improper installation procedures can result
in loosening or disengagement of the steering link rod. This can
cause a sudden, unexpected loss of boat control, resulting in
serious injury or death due to occupants being thrown within or
out of the boat. Always use required components and follow
instructions and torque procedures.
a - Special washer head bolt (10‑849838)
b - Flat washer (2)
c - Nylon insert locknut (11‑826709113)
d - Nylon insert locknut (11‑826709113)
Description Nm lb. in. lb. ft.
Special washer head bolt 27 20
Nylon insert locknut "d" 27 20
Nylon insert locknut "c" Tighten until seats, then back off 1/4 turn
Assemble steering link rod to steering cable with two flat washers
and self‑locking nylon insert locknut. Tighten locknut until it seats,
then back nut off 1/4 turn.
Assemble steering link rod to engine with special washer head bolt
and self‑locking nylon insert locknut. First torque bolt, then torque
locknut to specifications.
Fuse Replacement
IMPORTANT: Always carry spare 5 and 20 amp fuses.
To Next Page
Loading...
Need help?
General
