Mercury 200 Optimax User Manual

MAINTENANCE
61
The electrical wiring circuits on the outboard are protected from
overload by fuses in the wiring. If a fuse is blown, try to locate and
correct the cause of the overload. If the cause is not found, the fuse
may blow again.
Open the fuse holder and look at the silver colored band inside the
fuse. If band is broken, replace the fuse. Replace fuse with a new
fuse with the same rating.
a
b
52
2020
20
c
e
d
f
g
d
h
28750
a - Good fuse
b - Blown fuse
c - Diagnostic circuit ‑ 2 amp fuse
d - Spare fuse slot
e - SmartCraft data bus circuit ‑ 5 amp fuse
f - Ignition coil circuit ‑ 20 amp fuse
g - Accessories/cowl mounted tilt switch/wake power to
ECM ‑ 20 amp fuse
h - Electric fuel pump/ECM driver power/oil pump circuit/
injectors ‑ 20 amp fuse

Mercury 200 Optimax Specifications

General

Brand	Mercury
Model	200 Optimax
Category	Outboard Motor
Language	English