MAINTENANCE
64
Each anode requires periodic inspection, especially in salt water
which will accelerate the erosion. To maintain this corrosion
protection, always replace the anode before it is completely
eroded. Never paint or apply a protective coating on the anode as
this will reduce effectiveness of the anode.
The gearcase has two corrosion control anodes, one on each side.
A third anode is installed on the bottom of the transom bracket
assembly.
a - Anode (2) on each side
of gearcase
b - Anode on transom
bracket assembly
Battery Inspection
The battery should be inspected at periodic intervals to ensure
proper engine starting capability.
IMPORTANT: Read the safety and maintenance instructions
which accompany your battery.
1. Turn off the engine before servicing the battery.
2. Add water, as necessary, to keep the battery full.
3. Make sure the battery is secure against movement.
4. Battery cable terminals should be clean, tight, and correctly
installed. Positive to positive and negative to negative.
5. Make sure the battery is equipped with a non‑conductive
shield to prevent accidental shorting of battery terminals.
To Next Page
Loading...
Need help?
General
