OPERATION
43
Engine Break-in Procedure - Vary the throttle setting during the first hour of operation. During the first hour of
operation, avoid remaining at constant speed for more than two minutes and avoid sustained wide open throttle.
MODELS WITHOUT OIL INJECTION
Engine Break-in Fuel Mixture - Use a 25:1 (4%) gasoline/oil mixture in the first tank of fuel. After the break-in fuel
mixture is used up, use a 50:1 (2%) gasoline/oil mixture.
Engine Break-in Procedure - Vary the throttle setting during the first hour of operation. During the first hour of
operation, avoid remaining at constant speed for more than two minutes and avoid sustained wide open throttle.
Starting The Engine - Electric Start Remote Control Models
Before starting, read the Pre-Starting Check List, Special Operating Instructions, and Engine Break-in Procedure
in the Operation Section.
CAUTION
Never start or operate your outboard (even momentarily) without water circulating through all the cooling water
intake holes in the gearcase to prevent damage to the water pump (running dry) or overheating of the engine.
1. Make sure the cooling water intake is submerged.
To Next Page
Loading...
Need help?
General
