EasyManuals Logo
Home>Mercury>Engine>6.2L MPI

Mercury 6.2L MPI User Manual

Mercury 6.2L MPI
121 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #107 background imageLoading...
Page #107 background image
Engine Runs Rough, Misses, or Backfires
Possible Cause Remedy
Clogged fuel filter. Replace filter.
Stale or contaminated fuel. Drain fuel tank. Fill with fresh fuel.
Kinked or clogged fuel line or fuel tank vent line.
Replace kinked lines or blow out lines with compressed air to remove
obstruction.
Flame arrestor dirty. Clean the flame arrestor.
Faulty ignition system component. Service ignition system.
Idle speed too low. Have EFI system checked by an authorized Mercury MerCruiser dealer.
EFI system fault. Have EFI system checked by an authorized Mercury MerCruiser dealer.
Poor Performance
Possible Cause
Remedy
Throttle not fully open. Inspect the throttle cable and linkages for proper operation.
Damaged or improper propeller. Replace the propeller.
Excessive bilge water. Drain and check for cause of entry.
Boat overloaded or load improperly distributed. Reduce load or redistribute load more evenly.
Flame arrestor dirty. Clean the flame arrestor.
Boat bottom fouled or damaged. Clean or repair as necessary.
Ignition problem.
See Engine Runs Rough, Misses, or Backfires.
Engine overheating.
See Excessive Engine Temperature.
EFI system fault. Have EFI system checked by an authorized Mercury MerCruiser dealer.
Excessive Engine Temperature
Possible Cause
Remedy
Water inlet or seacock closed. Open.
Drive belt loose or in poor condition. Replace or adjust belt.
Seawater pickups or sea strainer obstructed. Remove obstruction.
Faulty thermostat. Replace.
Coolant level (if equipped) low in closed cooling section.
Check for cause of low coolant level and repair. Fill system with
proper coolant solution.
Heat exchanger or fluid cooler plugged with foreign material.
Clean heat exchanger, engine oil cooler, and transmission oil
cooler (if equipped).
Loss of pressure in closed cooling section. Check for leaks. Clean, inspect, and test pressure cap.
Faulty seawater pickup pump. Repair.
Seawater discharge restricted or plugged. Clean exhaust elbows.
Insufficient Engine Temperature
Possible Cause
Remedy
Faulty thermostat. Replace.
Low Engine Oil Pressure
Possible Cause
Remedy
Insufficient oil in crankcase. Check and add oil.
Excessive oil in crankcase (causing it to
become aerated).
Check and remove required amount of oil. Check for cause of excessive oil
(improper filling).
Diluted or improper viscosity oil.
Change oil and oil filter, using correct grade and viscosity oil. Determine
cause for dilution (excessive idling).
Section 6 - Troubleshooting
90-8M0128973 eng MAY 2017 Page 101

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 6.2L MPI and is the answer not in the manual?

Mercury 6.2L MPI Specifications

General IconGeneral
BrandMercury
Model6.2L MPI
CategoryEngine
LanguageEnglish

Related product manuals