Battery Inspection
The battery should be inspected at periodic intervals to ensure proper engine
starting capability.
IMPORTANT: Read the safety and maintenance instructions which accompany
your battery.
1. Turn off the engine before servicing the battery.
2. Ensure the battery is secure against movement.
3. Battery cable terminals should be clean, tight, and correctly installed.
Positive to positive and negative to negative.
4. Ensure the battery is equipped with a nonconductive shield to prevent
accidental shorting of battery terminals.
Fuel System
!
WARNING
Fuel is flammable and explosive. Ensure that the key switch is off and the
lanyard is positioned so that the engine cannot start. Do not smoke or allow
sources of spark or open flame in the area while servicing. Keep the work
area well ventilated and avoid prolonged exposure to vapors. Always check
for leaks before attempting to start the engine, and wipe up any spilled fuel
immediately.
Before servicing any part of the fuel system, stop the engine and disconnect
the battery. Drain the fuel system completely. Use an approved container to
collect and store fuel. Wipe up any spillage immediately. Material used to
contain spillage must be disposed of in an approved receptacle. Any fuel
system service must be performed in a well‑ventilated area. Inspect any
completed service work for sign of fuel leakage.
FUEL LINE FILTER
Inspect the fuel line filter. If the filter appears to be contaminated, remove and
replace.
IMPORTANT: Visually inspect for fuel leakage from the filter connections by
squeezing the primer bulb until firm, forcing fuel into the filter.
MAINTENANCE
52 eng
To Next Page
Loading...
Need help?
General
