3. Set the spark plug gap to specification.
Spark Plug
Spark plug gap 1.0 mm (0.040 in.)
4. Before installing spark plugs, clean off any dirt on the spark plug seats.
Install plugs finger‑tight, and then tighten 1/4 turn or torque to
specifications.
Description
Nm lb‑in. lb‑ft
Spark plug 27 – 20
Lubrication Points
1. Lubricate the following with Extreme Grease or 2‑4‑C with PTFE.
Tube Ref
No.
Description Where Used Part No.
Extreme Grease Propeller shaft 8M0071842
95
2-4-C with PTFE Propeller shaft 92-802859A 1
•
Propeller shaft ‑ Refer to Propeller Replacement for removal and
installation of the propeller. Coat the entire propeller shaft with
lubricant to prevent the propeller hub from corroding and seizing to the
shaft.
2. Lubricate the following with Quicksilver or Mercury Precision Lubricants
2‑4‑C with PTFE or Extreme Grease.
MAINTENANCE
eng 65
To Next Page
Loading...
Need help?
General
