Mercury 8 User Manual

ENGINE INSTALLATION
107
4. Power trim models ‑ To prevent a loss of the outboard, secure
the outboard to the transom with the two transom bracket
clamp screws and four mounting bolts. Drill two
7.9 mm (5/16 in.) holes through the upper set of transom
bracket mounting holes and drill two holes through the lower
set of mounting holes or mounting slots. Fasten with four bolts,
flat washers, and locknuts. Use a marine waterproofing sealer
in the holes and around the bolts to make the installation water
tight. Tighten the bolts to the specified torque.
a
b
c
a
b
a
28967
d
a - Locknut (4)
b - Washer (4)
c - Bolts (4)
d - Transom bracket clamp
screws (2)
Description Nm lb. in. lb. ft.
Transom bracket mounting bolts 13.5 10
Remote Control Installation
STEERING CABLE
1. Lubricate the entire cable end with Mercury Precision or
Quicksilver 2‑4‑C with Teflon.
28722
Tube Ref No. Description Where Used Part No.
95
2-4-C Marine
Lubricant with Teflon
Steering cable end 92-802859A1

Mercury 8 Specifications

General

Brand	Mercury
Model	8
Category	Outboard Motor
Language	English