MCM MODELS - BRAVO AND BLACKHAWK DRIVES SERVICE MANUAL NUMBER 23
Page 2A-4 90-861326--1 MARCH 1999
12. Support engine with suitable sling through lifting eyes on engine and remove front and
rear engine mounting bolts. Retain hardware.
75505
b
b
a
a-Suitable Sling
b-Engine Lifting Eyes
13. Carefully remove engine. DO NOT hit power steering control valve.
Installation
Engine Installation/Alignment
1. Be certain fiber washers (cemented in place) on inner transom plate are present. Inspect
fiber washers. Replace if worn or damaged.
2. Install double wound lockwashers onto inner transom plate inside fiber washer.
3. Be certain rear engine mount locknuts are in position as shown.
4. Lubricate exhaust bellows with soap and water to ease installation.
5. Lubricate engine coupler splines with Quicksilver Engine Coupler Spline Grease.
72023
d
a
b
c
a-Double Wound Lockwasher
b-Fiber Wound Lockwasher (Cemented In Place)
c-Inner Transom Plate Mount (Engine Support)
d-Locknuts (Engine Mounting Bolts)
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General