MCM MODELS - BRAVO AND BLACKHAWK DRIVES SERVICE MANUAL NUMBER 23
Page 2A-18 90-861326--1 MARCH 1999
7. Return remote control throttle lever to idle position and ensure that throttle plate is
completely closed.
75452
a
a-Throttle Plate
8. Reinstall flame arrestor and tighten clamp securely.
IMPORTANT: Adjust shift cables as outlined in appropriate Sterndrive Service
Manual.
9. Refer to appropriate Sterndrive Service Manual and install and adjust drive unit and
remote control shift cables, using hardware retained.
Power Steering Connections
IMPORTANT: After fluid hose installation in the following, bleed power steering
system as outlined in SECTION 1B - “Maintenance” of this manual, or refer to the
appropriate Stern Drive Service Manual.
CAUTION
Route hoses exactly as shown below. This will help avoid stress on the hose fittings
and will help avoid kinks in the hose.
IMPORTANT: Make hydraulic connections as quickly as possible to prevent fluid
leakage.
IMPORTANT: Be careful not to cross-thread or over- tighten fittings.
1. Connect both hydraulic hose fittings. Front hose from the cooler. Rear hose from pump.
2. Torque both fittings to 23 lb-ft (31 Nm). Route hoses as shown for each model.
75720
a
All Models
a-Hose Fittings
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General