MULTI-PORT FUEL INJECTION DISASSEMBLY AND REASSEMBLY
SERVICE MANUAL NUMBER 23
90-861326--1 MARCH 1999 Page 5C-41
INSTALLATION
1. Place the throttle body gasket between the throttle body and the adapter.
2. Place the throttle body on the adapter. Install the screws and torque to 75 lb-in. (8.5 Nm).
3. Connect the harness connectors to the TP sensor and IAC valve.
4. Connect the throttle cable to the throttle lever.
5. Place the flame arrestor over the throttle body and tighten the clamp.
Plenum
NOTICE
Refer to “Precautions” in this section, BEFORE proceeding.
REMOVAL
1. Remove the engine covers from plenum.
75644
a
a-Engine Covers
2. Disconnect the throttle cable from the throttle body.
3. Remove the throttle body and adapter from the plenum.
75727
b
a
c
d
a-Plenum
b-Adapter Gasket
c-Throttle Body
d-Nut (3)
4. Remove the breather hose from the plenum.
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General