MIE MODELS - HURTH TRANSMISSION SERVICE MANUAL NUMBER 23
Page 2D-20 90-861326--1 MARCH 1999
2. Check shift lever positioning as indicated.
IMPORTANT: Ensure that shift lever is positioned approximately 10
° aft of vertical
when in the neutral detent position and that the distance (“c”) between studs in the
following is set at 7-1/8 in. (318 mm). If necessary, loosen clamping bolt and position
lever so that dimension “c” is as shown when in the neutral detent position and
retighten bolt.
73587
b
c
a
d
Typical Hurth Transmission Shown
a-Shift Lever
b-Lever, In Neutral Detent, Must Be Approximately 10
° Aft Of Vertical
c-Dimension Between Studs - 7-1/8 in. (318 mm)
d-Clamping Bolt
3. Place remote control shift lever, and transmission shift lever, in neutral position.
4. Remove nuts and washers from shift cable attaching studs.
5. Locate center of remote control and control shift cable play (backlash), as follows:
a. Ensure that remote control is in neutral position.
b. Push in on control cable end with enough pressure to remove play, and mark
position “a” on tube.
c. Pull out on control cable end with enough pressure to remove play, and mark
position “b” on tube.
d. Measure distance between marks “a” and “b,” and mark position “c,” half-way
between marks “a” and “b.”
22024
a
b
c
c
72603
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General