MULTI-PORT FUEL INJECTION DISASSEMBLY AND REASSEMBLY SERVICE MANUAL NUMBER 23
Page 5C-12 90-861326--1 MARCH 1999
2. Apply Loctite 242 to threads of studs. Using a stud driver, torque studs to 165 lb-in.
(18.6 Nm).
72792
a
b
a-Throttle Body
b-Throttle Body Mounting Studs
NOTE: If Boat is equipped with Quicksilver Zero Effort Controls, the throttle cable mounting
stud must be in the most forward position on throttle lever.
73855
a
a-Position For Zero Effort Controls
3. Connect throttle linkage. Secure cable barrel anchor stud with locknut and tighten
securely. Secure cable end guide to lever stud. Install locknut on stud until it contacts
end guide.
72791
a
b
a-Cable Barrel Anchor Stud
b-Locknut
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General