DRIVE SHAFT / PROPELLER SHAFT MODELS SERVICE MANUAL NUMBER 23
Page 8F-4 90-861326--1 MARCH 1999
10. Install drive shaft and check alignment. (Refer to SECTION 2B for engine and drive shaft
alignment if engine was removed.)
11. Using Quicksilver U-Joint and Gimbal Bearing Grease, grease ball bearing through
grease fitting.
5
1
2
3
4
5
6
7
8
11
9
8
10
12
8
8
8
13
14
15
16
17
18
19
20
21
22
23
Flywheel Housing/Output Shaft Housing
1-Output Shaft
2-O-Rings
3-Snap Ring - Ball Bearing
4-Ball Bearing
5-Shaft Bearing
6-Snap Ring - Output Shaft
7-Rear Engine Mount
8-Lockwasher
9-Screw (4)
10 - Screw (6)
11 - Flywheel Housing
12 - Plate
13 - Screw (2)
14 - Nut (1)
15 - Bolt (4)
16 - Washer (1)
17 - Clamp (1)
18 - Stud (1)
19 - Gasket
20 - Cover - Flywheel
21 - Screw (7)
22 - Coupling - Engine
23 - Bushing
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General