32
Motherboard User’s Guide
Ring, or traffic on the network adapter. You must use an ATX power supply in
order to use this feature.
Keyboard Power On
If you enable this item, the system can automatically resume by pressing any
keys, power key, or typing in the password on the keyboard. You must use an
ATX power supply in order to use this feature.
PCI / Plug and Play Setup Page
This page sets up some parameters for devices installed on the PCI bus and
those utilizing the system plug and play capability.
Primary Graphics Adapter
This itme indicates if the primary graphics adapter uses the OnChip VGA, PCI
or AGPro.
Allocate IRQ to PCI VGA
If this item is enabled, an IRQ will be assigned to the PCI VGA graphics system.
You set this value to No to free up an IRQ.
PCI IDE BusMaster
This item enables or disabled the DMA under DOS mode. We recommend you to
leave this item at the default value.
CMOS SETUP UTILITY – Copyright (C) 1985-2004, American Megatrends, Inc.
PCI / Plug and Play Setup
Help Item
Primary Graphics Adapter AGPro
Allocate IRQ to PCI VGA Yes
PCI IDE BusMaster Disabled
No: lets the BIOS configure all the
devices in the system.
YES: lets the operating system
configure Plug and Play (PnP) devices not
required for boot if your system has a
Plug and Play operating system.
: Move Enter: Select +/-/: Value F10: Save Esc: Exit
F1: General Help F9: Optimized Defaults
To Next Page
Loading...
Need help?
General
