To Next Page

To Previous Page

WARNING

Water temperatures above 50℃ can cause severe burns or death from scalding.

Children, the disabled and the elderly are at a high risk of being injured. Feel the water

temperature before bathing or showering. Do not leave children, disabled persons, or the

elderly unsupervised. The Australian Standards AS 3498 gives full details of the

requirements for supply of controlled temperatures to ablution outlets (bathrooms) and is

required to conform to all plumbing codes within Australia.

PROHIBITED

3.4 GENERAL GUIDELINES

3.3 SAFETY GUIDELINES

Ensure the following warnings and instructions are read and understood before commencing

installation.

Carefully plan where you intend to install the water heater.

Please ensure: The water heater has adequate space for natural ventilation；

Is located where water leakage will not damage surrounding areas

Has all transit protection/packaging removed.

Check the name plate and gas type label for the correct GAS TYPE, GAS PRESSURE, WATER

PRESSURE and ELECTRIC RATING; If this unit does not match operating condition, do not

install and consult with your supplier.

If any problem should occur, turn off the gas, all hot water taps and call a licensed professional

Installation and service must be performed by a licensed professional (for example, a licensed

plumber or gas fitter).

The licensed professional is responsible for the correct installation of the water heater and for

compliance with all relevant national, state and local regulations.

The water heater must be installed OUTDOORS ONLY. DO NOT install water heater indoors.

Not to be used as a pool heater.

Do not store or use gasoline or other flammables, vapors, or liquids in the vicinity of this

appliance. Vapors from flammable liquids will explode and catch fire causing death or severe

burns.

Do not reverse the water and/or gas connections as this will damage the gas valves and can

cause severe injury or death. Follow the diagram on p. 6 & 7 when installing your water

heater.

Do not use this appliance if any part has been in contact with or been immersed in water.

Immediately call a licensed professional to inspect and/or service the unit if necessary.

Do not disconnect the electrical supply if the ambient temperature will drop below freezing.

The Freeze Prevention System only works if the unit has electrical power. The warranty will

not be covered if the heat exchanger is damaged due to freezing. Refer to the section on

the Freeze Prevention System on p. 19 for more information.

Midea M26 User Manual

Questions and Answers: