Removal and Replacement
1. Remove shell. (see shell removal and installation)
2. Take out two corner boards, absorber sound, backboard, hollow plate.
3. Contrarotate nut of siphon. Take out one way valve and gasket of siphon.
Part name: 1 – nut of siphon 2 – gasket of siphon 3 – one way valve
4. Remove two clamps for fixing connecting hoses with siphon.
5. Reverse the above procedure to install.
As the dishwasher basin fills with water, the air pressure in the pressure
switch hose increases. When the pressure reaches the aim of value, the
switch will act and give a signal to main control board. Then the drain
will be work.
Removal and Replacement
1. Remove shell. (see shell removal and installation)
2. Take out two corner boards, absorber sound,
backboard, hollow plate.
3. Unfix the sheet copper for fixing the pressure switch hose.
Pressure switch
Siphon
Gasket of air
breather
Clamp
Clamps
1
2
3
To Next Page
Loading...
Need help?
General
