Midea WQP6-3206B User Manual


SYMPTOM CHECK FOR THE FOLLOWING REMEDY
The water supply is turned off. Turn the water supply on.
Defective water fill valve. Replace the water fill valve.
Low water pressure. Minimum water pressure of 20 PSI.
Obstructed water fills valve or hose.
Disassemble and clean the water fill valve and
hose.
Damaged or defective wiring. Repair the wiring.
Defective pressure switch for high water
level safeguard.
Replace the pressure switch.
Defective flowmeter. Replace the flowmeter
Heavy water usage elsewhere in home.
Use dishwasher when water usage is at a
minimum.
3 in 1 lamp
twinkle
（ Dishwasher
will not fill with
water or will not
fill properly.）
Defective PCB assembly Replace the PCB assembly
Defective drain pump. Replace the drain pump.
Obstructed drainhose check the drainhose
Defective PCB assembly Replace the PCB assembly
Dishwasher will
not
pump out.
Damaged or defective wiring. Repair the wiring.
Low input voltage. The lowest input voltage is 198V
Defective Thermal resistor Replace the Thermal resistor
Damaged or defective wiring. Repair the wiring.
Too little water fill. See “Too little water fill.”
Defective micro-switch of heater elements
support assembly.
Replace the heater elements support assembly.
Defective heater element. Replace the heater element.
Dishwasher
runs but. will not
heat.
Defective PCB assembly Replace the PCB assembly
Defective micro-switch for overfall
safeguard
Replace the micro-switch
Damaged or defective wiring. Repair the wiring.
Defective PCB assembly Replace the PCB assembly
Glass lamp
twinkle
（ overfall
alarm）
Water leaks from dishwasher. See “Water leaks from dishwasher”
The door not close well close the door
Defective door switch contacts. Replace the door switch.
Defective door handle assembly. Replace the door handle assembly.
Damaged or defective wiring. Repair the wiring.
Do not work
when press
start
Defective PCB assembly Replace the PCB assembly
Dishwasher not level. Level the dishwasher.
Defective flowmeter. Replace the flowmeter
Clogged filter assembly. Clean the filter assembly.
Water siphons out Clean or Replace the One way valve
Too little water
fill.
Defective pressure switch. Replace the pressure switch.
Defective door switch contacts. Replace the door switch.
Defective door handle assembly. Replace the door handle assembly.
Damaged or defective wiring. Repair the wiring.
Dishwasher
runs with door
open.
Defective PCB assembly Replace the PCB assembly
Defective motor bearings. Replace the motor.
Defective motor capacitor. Replace the motor capacitor.
Damaged or defective wiring. Repair the wiring.
Motor hums but
will not start or
run.
Improper motor voltage. Replace the motor.
Motor windings shorted. Replace the motor.
Improper motor voltage. Replace the motor.
Defective motor capacitor. Replace the motor capacitor.
Motor trips out
on internal
thermal
overload
protector
Defective motor bearings. Replace the motor.
Repeated
dishwasher
Defective PCB assembly Replace the PCB assembly
Troubleshooting

Midea WQP6-3206B Specifications

General

Brand	Midea
Model	WQP6-3206B
Category	Dishwasher
Language	English