cycles.
A small amount of water (in sump area) is
normal.
This is necessary to keep the pump primed and is
drained automatically at the beginning of each
cycle.
Defective drain pump Replace the drain pump.
Defective Check plate Clean or Replace the Check plate
Water remains
in bottom
Defective One way valve Clean or Replace the One way valve
Detergent allowed to stand too long in the
dispenser or excessive amounts of
detergent are being used.
Spotting or
filming on
glasses
(reposition of
food soil).
Improper loading of dishes, pots,
pans, and nesting of silverware.
Instruct the customer on proper use of dishwasher
detergent. Refer to the
owner’s manual.
Debris in bottom of tub sump area. Clean out the sump area.
Pump parts were not properly installed.
Inspect the pump and correct and installation
errors.
Noisy pump
assembly.
Impellers are not properly shimmed or are
rubbing.
Use the shim guage furnished in the impeller seal
kit. When the seal is properly shimmed the
impellers will be in the correct operating position.
Clogged filter assembly. Clean the filter assembly.
Dishware stop the sprayer revolve the sprayer before wash.
Improper loading of dishes, pots, pans,
and nesting of silverware.
Little detergent/rinse module
Select improper program
Refer to the owners manual.
Defective detergent/rinse module Replace the etergent/rinse module.
Defective spray arm. Check spray arm for proper rotation.
Too little water fill. See “Too little water fill” symptom.
Poor
washability.
Defective motor pump Replace the motor pump
Improper loading of dishes, pots, pans,
and nesting of silverware.
Select improper program
Instruct the customer on proper loading of the
dishwasher. Refer to the owners manual.
Poor drying of
dishes
Defective dispenser Replace the dispenser
Too much water fill. See previous symptom.
Defective tub seal. Replace the tub seal.
Defective softener gasket. Replace softener gasket.
Defective drain pump Replace the drain pump
Dishwasher not level. Level the dishwasher.
Soap suds leak from dishwasher. Refer to use and care manual.
Loose hose clamps. Tighten or replace hose clamps.
Loose heater element. Tighten heater element mounting nuts.
Defective sump seals. Replace the sump seals.
Motor and drain pump assembly not
seated properly with sump.
Remount the motor and drain pump assembly.
Water leaks
from
dishwasher.
Defective Heater elements support
assembly seals.
Remount Heater elements support assembly.
To Previous Page
Loading...
Need help?
General
