Cleaning and care
64
Cup sensor
The cup sensor is located underneath
the central spout.
Clean the cup sensor daily by hand
with warm water and a little washing-up
liquid.
Push the two locking catches
together (see arrows).
The cup sensor will be released.
Clean the cup sensor.
To replace it:
Push the cup sensor from underneath
into the holder on the central spout.
Stainless steel milk flask
The milk flask should be taken apart
and cleaned every day.
Clean all parts by hand only using
hot water and a little washing-up
liquid. Use the cleaning brush
supplied to remove milk residues
from the milk pipework if necessary.
Rinse all parts carefully under running
water.
Residual washing-up liquid can affect
the taste of milk from the machine and
the quality of the milk froth.
Dry all parts thoroughly.
Reassemble the milk flask.
To Next Page
Loading...
Need help?
General
