en-CA
52
Switching on and off (Fig. 29)
When you have charged the battery,
pull the charger plug out of the
charging socket on the bottom at the
rear of the PowerUnit.
For the best possible cleaning results,
always start the ComfortClean
function before switching on the
vacuum cleaner (see “Cleaning and
care” – “Activating the ComfortClean
function”).
Press the upper button on the handle
.
The vacuum cleaner will switch on using
the lowest power level.
Increasing the suction power (Fig. 30)
Press the lower button on the handle.
The higher power level is selected and
the LED lights up.
Press the button again to return to the
lower power level.
PowerUnit Solo (Fig. 31)
The PowerUnit can be used on its own
without the suction tube and
electrobrush as a quick way of
vacuuming up crumbs and lint in
specific areas.
Useful tip: This configuration is
particularly suitable when using the
three-piece accessory set (see “Using
the accessories supplied”).
Cleaning and care
Risk of injury caused by rotating
roller brush.
You can injure yourself on the rotating
roller brush.
Always switch the vacuum cleaner
off before cleaning and caring for it.
Use the On/Off switch on the handle
to do this.
Filter system (Fig. 32)
Screw cap
Fine dust filter
Dust container
d Prefilter
e Dust container flap
Activating the ComfortClean function
(Fig. 33)
Always run the interim cleaning function
for the fine dust filter before emptying
the dust container. You should also run
it whenever the suction power begins to
drop.
This enables the vacuum cleaner to
achieve the very best cleaning
performance again right away.
Turn the screw cap 3times by 180°.
When turning the cap, you will hear a
noise, which is a normal part of how the
ComfortClean self-cleaning function
works.
Emptying the dust container (Fig. 34)
Empty the dust container at the latest
when the dust has reached the Max.
marking on the dust container.
To Next Page
Loading...
Need help?
General
