EasyManua.ls Logo

Miele G 676 User Manual

Miele G 676
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #39 background imageLoading...
Page #39 background image
Cleaning and care
Cleaning the filter in the water
inlet
A filter is incorporated in the screw con-
nection of the valve on the water inlet
hose. The filter must be cleaned when
dirty, otherwise insufficient water flows
into the wash cabinet.
The plastic housing of the water
connection contains an electrical
component. It must not be dipped
in water.
Fitting an in-line water filter
If the mains water contains a large num-
ber of insoluble substances, we recom-
mend fitting a large area filter in the
connection between the stopcock and
the water inlet hose threaded union.
These filters can be obtained from the
Miele Spares Department (Part No.:
75577).
To clean the filter
Disconnect the appliance from the
mains supply (switch off at the main
socket and pull out the plug, switch
off the appropriate circuit at the fuse-
box or withdraw the mains fuse).
Turn off the stopcock and unscrew
the inlet hose.
Carefully remove the rubber seal.
Withdraw the filter using pointed
pliers and clean by rinsing under run-
ning water.
Replace filter and seal. Make sure
they are sitting correctly!
Screw back into place on the water
inlet, taking care that it goes back on
straight.
Turn on the stopcock gradually to
test for leaks.
If there is a leak:
Screw the connections on more
tightly.
Cleaning and care
39

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Miele G 676 and is the answer not in the manual?

Miele G 676 Specifications

General IconGeneral
BrandMiele
ModelG 676
CategoryDishwasher
LanguageEnglish

Summary

Warning and safety instructions

General Safety and Usage Precautions

Details safe usage and warnings against personal injury.

Material Damage Prevention Notes

Provides essential notes to prevent damage to the appliance and property.

Before using for the first time

Initial Setup and Loading Guide

Outlines essential steps before initial use, including setup and loading.

Opening and closing the door

Water softener

Setting Water Hardness Level

Details how to set the water hardness level for optimal performance.

Filling the Salt Reservoir

Provides instructions on correctly filling the salt reservoir.

Adding rinse aid

Items not suitable for dishwashers

Adding detergent

Detergent Dosage and Preventive Measures

Provides guidance on detergent dosage and preventive measures.

Choosing a programme

Programme Selection Basics

Guides on selecting the appropriate wash programme.

Programme chart

Programme and Detergent Guide

A chart detailing wash programmes, their uses, and detergent requirements.

Programme Cycles and Consumption

Provides details on programme cycles, energy, water consumption, and duration.

Switching on and off

Appliance Power and Programme Start

Instructions for switching the appliance on and starting a programme.

Switching Off and Programme Interruption

Explains how to switch off the appliance and interrupt programmes.

Programme Change and Unloading

Details how to change programmes and unload the dishwasher.

Cleaning and care

Extended water inlet time

Problem solving guide

Common Faults and Solutions

Lists common faults and their solutions.

Indicator Light Fault Diagnosis

Helps diagnose issues based on flashing indicator lights.

Installation instructions

Freestanding Dishwasher Setup

Covers general setup for freestanding models and door height adjustment.

Establishing Decor Panel Height

Details how to establish the correct height for the decor panel.

Electrical connection

Mains Connection and Safety

Covers safe electrical connection, wiring codes, and safety warnings.

Plumbing

Water Inlet Connection

Details how to connect the appliance to the water supply.

Drainage System and Venting

Covers the drainage system and procedures for venting.

Related product manuals