EasyManua.ls Logo

Miele G 676 User Manual

Miele G 676
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #72 background imageLoading...
Page #72 background image
6.Adjusting the door springs
The door springs are correctly adjusted
when a half opened door (approx. 45°
opening angle) remains in that position
when released.
If the door drops down, then the door
springs need to be tightened.
If, however, it rises up, then the springs
need to be released.
The adjusting screw is located in the
upper front strip at the left hand side of
the dishwasher.
Open the dishwasher door.
Adjust the door spring using a Torx
screwdriver until it is correctly bal-
anced:
– turn clockwise = tighten
– turn anti-clockwise = loosen.
7.Level and secure the
dishwasher
To ensure the stability of the dish-
washer it must be screwed to the con-
tinuous worktop after it has been posi-
tioned.
Fit the securing pieces into the slots
on both the left and right hand sides.
Push the dishwasher into the recess.
Open the dishwasher door.
The hole in the securing piece must
line up with the oval hole in the niro
steel plate.
Installing integrated “i” Dishwashers
72

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Miele G 676 and is the answer not in the manual?

Miele G 676 Specifications

General IconGeneral
BrandMiele
ModelG 676
CategoryDishwasher
LanguageEnglish

Summary

Warning and safety instructions

General Safety and Usage Precautions

Details safe usage and warnings against personal injury.

Material Damage Prevention Notes

Provides essential notes to prevent damage to the appliance and property.

Before using for the first time

Initial Setup and Loading Guide

Outlines essential steps before initial use, including setup and loading.

Opening and closing the door

Water softener

Setting Water Hardness Level

Details how to set the water hardness level for optimal performance.

Filling the Salt Reservoir

Provides instructions on correctly filling the salt reservoir.

Adding rinse aid

Items not suitable for dishwashers

Adding detergent

Detergent Dosage and Preventive Measures

Provides guidance on detergent dosage and preventive measures.

Choosing a programme

Programme Selection Basics

Guides on selecting the appropriate wash programme.

Programme chart

Programme and Detergent Guide

A chart detailing wash programmes, their uses, and detergent requirements.

Programme Cycles and Consumption

Provides details on programme cycles, energy, water consumption, and duration.

Switching on and off

Appliance Power and Programme Start

Instructions for switching the appliance on and starting a programme.

Switching Off and Programme Interruption

Explains how to switch off the appliance and interrupt programmes.

Programme Change and Unloading

Details how to change programmes and unload the dishwasher.

Cleaning and care

Extended water inlet time

Problem solving guide

Common Faults and Solutions

Lists common faults and their solutions.

Indicator Light Fault Diagnosis

Helps diagnose issues based on flashing indicator lights.

Installation instructions

Freestanding Dishwasher Setup

Covers general setup for freestanding models and door height adjustment.

Establishing Decor Panel Height

Details how to establish the correct height for the decor panel.

Electrical connection

Mains Connection and Safety

Covers safe electrical connection, wiring codes, and safety warnings.

Plumbing

Water Inlet Connection

Details how to connect the appliance to the water supply.

Drainage System and Venting

Covers the drainage system and procedures for venting.

Related product manuals