Checking the water level
If the water pressure (flow rate at the
take-off point) is too low, i.e. less than
1.0 bar, too little water will flow into the
wash cabinet.
To ensure an accurate assessment
open the stopcock fully and run the
PRE-WASH programme once (with-
out crockery) to bring water into the
system.
Run the PRE-WASH programme
again. After approx. 3 minutes open
the door and remove the bottom bas-
ket from the machine.
The water level is correct when dimen-
sion “X” is at least 4 mm.
If it measures less, then the water in-
take time must be increased, (see
section on extending water inlet
time).
Checking the water level
41
To Next Page
Loading...
