Miele G 676 User Manual

Comparison tests
Dishwasher G 6XX (see data plate for model number)
Test standard: IEC 436 / DIN 44990 / IEC 704 / prEN 50242
Amount washed: 6 place settings (half load)
Programme tested: UNIVERSAL PLUS 55 °
with “Top Solo”
Amount of detergent: 20 g
only in compartment II
Rinse aid dispensing: Setting 3 (approx. 3 ml, set at factory)
Measuring noise: Before starting a programme to measure noise, the
dishwasher door must first be opened completely.
Doing this will automatically close the vent exit for
the turbothermic drying process as in daily use.
Dishwashers with cutlery basket
Spoon inserts: Fit the two inserts on top of the cutlery basket, (see
Section on loading the dishwasher, spoon inserts).
Place three spoons at intervals in each insert.
Upper basket
Lower basket
Comparison tests
51

Miele G 676 Specifications

General

Brand	Miele
Model	G 676
Category	Dishwasher
Language	English

Summary

Warning and safety instructions

General Safety and Usage Precautions

Details safe usage and warnings against personal injury.

Material Damage Prevention Notes

Provides essential notes to prevent damage to the appliance and property.

Disposal and Heating Element Safety

Before using for the first time

Initial Setup and Loading Guide

Outlines essential steps before initial use, including setup and loading.

Opening and closing the door

Door Operation and Child Safety Lock

Water softener

Setting Water Hardness Level

Details how to set the water hardness level for optimal performance.

Filling the Salt Reservoir

Provides instructions on correctly filling the salt reservoir.

Adding rinse aid

Rinse Aid Indicators and Dispenser

Setting Rinse Aid Dosage

Items not suitable for dishwashers

Materials and Special Loading Notes

Adding detergent

Detergent Selection and Common Issues

Detergent Dosage and Preventive Measures

Provides guidance on detergent dosage and preventive measures.

Choosing a programme

Programme Selection Basics

Guides on selecting the appropriate wash programme.

Programme chart

Programme and Detergent Guide

A chart detailing wash programmes, their uses, and detergent requirements.

Programme Cycles and Consumption

Provides details on programme cycles, energy, water consumption, and duration.

Switching on and off

Appliance Power and Programme Start

Instructions for switching the appliance on and starting a programme.

Switching Off and Programme Interruption

Explains how to switch off the appliance and interrupt programmes.

Programme Change and Unloading

Details how to change programmes and unload the dishwasher.

Cleaning and care

Cleaning the Wash Cabinet Filters

Filter Combination Cleaning Details

Cleaning the Spray Arms

Cleaning Drain Pump and Non-Return Valve

Cleaning Water Inlet Filter

Cleaning Interior Surfaces and Door

Extended water inlet time

Extending Water Inlet Time Procedure

Problem solving guide

Common Faults and Solutions

Lists common faults and their solutions.

Indicator Light Fault Diagnosis

Helps diagnose issues based on flashing indicator lights.

Installation instructions

Freestanding Dishwasher Setup

Covers general setup for freestanding models and door height adjustment.

Establishing Decor Panel Height

Details how to establish the correct height for the decor panel.

Matching Door Height

Integrated Dishwasher Overview

Fitting Worktop Protection

Building into Niche

Fitting the Facia Panel

Aligning Facia Panel with Drawers

Fitting the Matching Door Front

Adjusting Door Springs

Levelling and Securing Dishwasher

Matching Plinth Facia

Electrical connection

Mains Connection and Safety

Covers safe electrical connection, wiring codes, and safety warnings.

Non-Rewireable Plugs

Plumbing

Water Inlet Connection

Details how to connect the appliance to the water supply.

Water Inlet Hose Routing

Drainage System and Venting

Covers the drainage system and procedures for venting.